3d-robotics GoPro HERO3 stabilization system Bedienungsanleitung PDF herunterladen

Parts

Tarot gimbal

GoPro HERO3 stabilization system

IRIS+ mounting screws

(2)

Configuration cable

Gimbals arrive preconfigured and ready

to fly. For information on changing

configuration and updating the

firmware, visit 3dr.com/learn.

Extra parts

servo cable

split-wire servo cable

rail mounting hooks (2)

X8/Y6/QUAD mounting hardware

(instructions included)

Remove the two screws securing the blue face plate,

and remove the plate.

face plate

remove

Slide camera into housing with

the lens nearest the top-right

corner.

Important note: Make sure that the WiFi on your GoPro

is turned OFF at all times when in use with IRIS+.

remove

1 Attach Camera

Place the blue face plate over the camera, and secure from the

back with the two original screws.

Add face plate.

tighten

Thread cables here.

Locate the black and white two-wire cable protruding

from the bottom of IRIS.

Thread the cables through the interface plate. Locate the pins

on the Tarot board. Connect the black wire to a - (ground) pin

and the white wire to the T (tilt) pin.

Follow these instructions to connect the gimbal to IRIS. This

will allow you to adjust the tilt of the camera in flight using the

controller. To enable automatic camera stabilization without

remote control, skip to the step 3: power.

Attach black wire

to ground (-).

ground (black)

tilt (white)

Attach white wire

to tilt (T).

2 Connect

GoPro not included

User Guide

1 2 3 4

Inhaltsverzeichnis

Seite 1 - 2 Connect

1PartsTarot gimbalGoPro HERO3 stabilization systemIRIS+ mounting screws(2)Configuration cableGimbals arrive preconfigured and ready to fly. For inform

Seite 2 - Operating the Gimbal

2Connect the gimbal power cable with the red connector to the matching cable protruding from the bottom of IRIS.3 PowerUsing the mounting screws, atta

Seite 3

3X8/Y6/QUAD Mounting InstructionsThis kit includes hardware to mount the gimbal to a 2014 RTF X8, Y6, or QUAD. To do this, you will need to disassembl

Seite 4 - 9 Attach Camera

4Rotate clockwise to level the camera.Rotate counterclockwise to tilt the camera down.For Non-3DR TransmittersTo calibrate a non-3DR transmitter to co

Kommentare zu diesen Handbüchern

Keine Kommentare

3d-robotics GoPro HERO3 stabilization system Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Video 3d-robotics GoPro HERO3 stabilization system herunter. 3D Robotics GoPro HERO3 stabilization system User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Video 3d-robotics GoPro HERO3 stabilization system